1. Mondo Sport Slate require periodical maintenance, the frequency of which will depend on the volume of foot traffic.
2. The adoption of a regular program, following the procedures outlined below will ensure a more than adequate appearance level while obtaining the maximum use of the flooring.
3. It is recommended that once the floor is installed, the finished floor should be swept clean of all debris and the initial wash be done approximately 48 hours after completion of the installation.
4. To avoid possible damage to the flooring, precautions should be taken in order to ensure that the following products and equipment are never used to maintain it. They are:
   1. STEEL WOOL OR ABRASIVE BRUSHES.
   2. ABRASIVE OR VERY ALCALINE CLEANERS.
   3. SOLVENTS OF ANY TYPE
5. The frequency that one must clean the flooring will depend on the intensity of foot traffic, and the type of installation involved and the size of the area covered.
6. The use of a detergent is necessary to clean Mondo’s flooring. Note: This detergent must be of a mild non-phosphate type with a neutral pH (Taski Profi is the recommended cleaning product). The procedure and equipment to be used will be as follows:
   1. Prior to washing, vacuum all debris and loose dirt from the floor. Then, wash the floor with the above detergent diluted in warm water at a ratio recommended by the manufacturer. Allow the solution to stand approximately 10 minutes after application.The use of an auto-scrubber equipped with soft nylon brushes or red pad is recommended. Scrub the area thoroughly in multiple directions. Do not use the vacuum immediately.
   2. With the use of an auto-scrubber, pass over the washed area and vacuum up the solution and allow floor to dry. If the floor is very dirty, the detergent ratio should be increased and let the solution stand for 15 minutes to allow the detergent to loosen the dirt.
   3. Rinse the floor thoroughly with clean fresh water. Repeat rinsing as required to remove all residue. Note: The appearance of a white film following washing and rinsing is an indication that the rinsing procedure was not adequate, in such cases, repeat the rinsing procedure until the residue has been removed.

YEARLY MAINTENANCE:

Aproximately once a year the sport surface should be cleaned following the above procedure but using a higher pH detergent (Taski Linostrip is the recommended product). This will allow the remove the build-up of parafin (waxes) on the surface of the material.

For assistance, please contact:
Mondo Technical Department
2655 Francis Hughes, Laval (Quebec) Canada H7L 3S8
E-mail: technical@mondousa.com
Canada 1-800-663-8138??USA 1-800-361-3747

Back to top.
Back to Mathusek Rubber Floor Division

© Copyright & Site Design by Internet Imaging